Is 4mm Brake Pads OK?

Is 4 mm brake pads OK?

Therefore, anywhere from 3mm to 4mm is the recommended thickness to replace brake pads in most cases.

You may be able to get away with slightly less thickness, but certainly nothing less than 2mm.

At that point, braking performance can suffer and damage to your brake rotors is more likely..

What thickness do brake pads need to be replaced?

Brake pads should typically be replaced when approximately 1/8″ to 3/16″ of friction material remains on the steel backing plate. Brake rotors should be replaced before their thickness has reached the prescribed “Worn Rotor Minimum Thickness” limit (expressed in millimeters) engraved on the edge of the brake disc.

How long will 3mm brake pads last?

As a general rule of thumb, there’s about a 40,000 mile range in play. Average brake pad life is somewhere around 25,000 to 65,000 miles.

What is acceptable brake thickness?

The brake pad thickness has to be at least 1⁄4 inch (6.4 mm) or more for its proper functioning. Remember, if the thickness is between 6.4 to 3.2 mm it will save the brake system from severe damages.

How long will 4mm brake pads last?

MG3 brake pads last on average over 60,000 miles, so at 4mm they easily have 30,000 miles left.

Is 5 mm on brake pads OK?

How is brake pad wear measured? Pad wear is calculated in millimetres. The confusion comes in the way this is communicated to drivers. … If you’re told you have 5mm of pad remaining you might replace the pads too late to be safe, or too soon to get full value for money out of them.